Redstone Companion · Learn Open simulator →

Strong vs. Weak Power

Redstone has two kinds of block power: strong power flips torches and feeds new dust, while weak power only triggers components touching the block. Mixing them up breaks half of all circuits.

Bedrock Edition · Updated 2026-06-02

What's the difference between strong and weak power?

When redstone powers a solid block, that power comes in two strengths. Strong power is the “real deal”: a strongly powered block can feed power into a fresh length of dust running onto it and can flip a redstone torch attached to it. Weak power is gentler: it can light a lamp or trigger a component sitting directly against the block, but it cannot push into a new piece of dust or turn off a torch.

This one distinction is behind a huge share of “why won't it work” moments. The block looks powered — but the kind of power it carries decides what it can actually do.

What strongly powers a block?

Sources that strongly power the block they point into include a lever, button, repeater (out its front), and a torch (into the block above it). A redstone block strongly powers every block touching it. By contrast, dust running onto a block only weakly powers it. Watch the difference below.

Toggle the source and follow the signal. Notice how it propagates along dust — and where, if a solid block sits in the way, weak power stops it dead.
Open full simulator →

Why does my torch stay on?

The classic symptom: dust runs onto a block, a torch is attached to that block, you expect the torch to switch off — and it stays lit. That's because dust gives the block only weak power, and a torch ignores weak power. To flip the torch you need a strong source on that block: put a repeater or a lever feeding it instead of bare dust. A redstone block placed against it works too.

Watch the redstone block strongly power everything touching it — including blocks that then pass power onward, unlike weakly powered blocks.
Open full simulator →

Key facts

Bedrock vs. Java: weak power is absorbed

In Bedrock Edition, a solid block holding only weak power absorbs it — the power does not jump into a second, separate piece of dust, and it won't turn off an attached torch. Only strong power does those jobs. This is deliberate Bedrock behaviour and a frequent gotcha when porting Java builds. This simulator enforces it, so plan your wiring with the strong/weak split in mind from the start.